Hebei Jinxuanfa Silk Screen Co., Ltd.

enLanguage

How To Install A Mosquito Screen Door

Jul 04, 2025 Leave a message

1. Open the package. Remove the two screens and unwind the coiled magnetic strip.
2. Thread the magnetic strip through the screen. (This is not necessary for combination and magnetic block screens.) To facilitate downward threading, first round the end of the magnetic strip and thread it from the center. (When threading the magnetic strip, stand on a slightly elevated surface or on a bed. Shake the strip as you go, positioning the center of gravity downward for easier threading.) The flat surfaces of the magnetic strip are aligned for attraction. Be careful not to reverse the polarity of the strip. Since the door height is fixed, you can trim off any excess magnetic strip. (When cleaning the screen door in winter, do not pull hard. Simply flip the strip over and straighten it, and it will slide right off.)
3. Install the screen with the magnetic strip on the door frame. Locate the center of the door. Important points: During installation, allow the screen door to overlap the floor by about a centimeter. The magnetic buckle should not touch the ground. The center should be slightly raised (install it parallel to the ground first, then raise the center by about a centimeter. Don't worry about the screen door tilting because the curtain will block it. Imagine that even without the magnetic strip, raising the center will naturally pull the two screen doors together). Don't tighten too much on the sides. With proper installation, every screen door will close easily and naturally! During installation, don't tighten with thumbtacks or double-sided tape yet. First, secure the screen door in the center and top corners. Slightly tighten the center and bottom edges. Move the door in and out to see if it closes easily and naturally. Once you do, secure it securely. If the magnetic strip's flat surfaces aren't attracted to one side, the positive and negative poles may be reversed.

For wooden door frames, nail a piece of foam insert to each end of the soft magnetic strip to prevent it from sagging and causing uneven bending. (If installing on an iron frame, aluminum door panel, or stainless steel, you can use special magic glue.)
4. Secure the small lace curtain above the door. You're done!